Zibro SM 18 113 Instruction Manual page 59

ATTENTION
If need suspending installation, the installation bracket should accord with all technical
requirements. The installation wall should be strong enough or actions to reinforce should be
taken. The connection between bracket and wall, bracket and the air conditioner should be firm,
stable and reliable. In case of any doubts or uncertainty do not attempt to install the unit but
have the support calculated and engineered by a skilled engineer.
Indoor units that can be used in combination
Length for one indoor unit
Difference in height between indoor and out-
door units
Difference in height between indoor units
Compressor stop/start frequency
Power source voltage
Settlement of outdoor unit
Anchor the outdoor unit with bolts, lock washers and nuts ø 10 mm or ø 8 mm tightly and horizontally on
a concrete or rigid mount.
A (mm) B (mm)
590 333
Drain joint installation
(see fig. 13)
Fit the seal into the drain elbow, then insert the drain joint into the base pan hole in the bottom of the out-
door unit, rotate 90° to assemble them securely. Connect the drain joint with an extension drain hose (not
included). In this way condensed water, which is produced during heating mode of the airconditioner, can
be drained away.
Number of connected units
Total of indoor units class kW
When indoor above outdoor unit
When indoor below outdoor unit
1 cycle time
Stop time
Voltage fluctuation
Voltage drop during start
Intverval unbalance
Strong
wind
Fig. 11
1-4
8.0 kW (nom.)
max. 15 m.
max. 10 m.
max. 10 m.
max. 10 m.
≥ 6 min.
≥ 3 min.
max. 10%
max. 15%
max. 3%
Air inlet
Air inlet
Air ourlet
Fig. 12
4
59