Replacing The Carbon Carbon Discs - Venduro RA 90 LP Manual

ENG
Maintaining the cooker hood with edge extraction
When removing the grease filters, it is recommended to protect the cooker using a piece of Sty-
rofoam or polystyrene. This way you avoid damaging the cooker in case the filters drop from your
hands. Pay attention if the cooker is no longer operating!
You can remove the grease filter by:
• Pushing the stainless steel cap away from you into the U-section (1).
• Lowering the front side of the filter (2).
Extra tip
You can keep the cooker hood system clean by boiling a pot with water, lemon juice (from one lemon)
and a glass of vinegar for 20 minutes. Have it boil with the cooker hood set at position 2 and then let
the cooker hood run for another 15 minutes.
In case of a plasma system, apply the same method and rinse the hydrosorb filter in water with
detergent. The grease filters can be cleaned in the dishwasher every 2 weeks.
Replacing the carbon carbon discs (if installed)
1. Open the tilting panel.
2. Remove the carbon disc.
3. Grab hold of the carbon filter and rotate to remove.
4. Once the carbon disc is entirely saturated, it must be replaced by a new one.
44