Advertisement
3. Check for misalignment or binding of moving
parts, breakage of parts, and any other condition
that affects the tool's operation. If damaged,
have the tool serviced before using. Many
accidents are caused by poorly maintained tools.
There is a risk of bursting if the tool is damaged.
Service
1. Tool service must be performed only
by qualified repair personnel.
2. When servicing a tool, use only identical
replacement parts. Use only authorized parts.
Specific Safety Rules
1. Keep hands away from Plate and
Rack Press during use.
2. Do not move workpiece while compressed.
3. Bolt to workbench before use.
4. Keep area under arbor plates clear. If arbor
plates rest on obstruction (i.e. bolt, debris,
etc.), it creates an uneven press, causing
excess stress and possible breakage.
5. Avoid off-center loads. Do not operate if
workpiece tilts or binds during compression.
6. STOP and release compression if you suspect
imminent structural failure. If safe, inspect
thoroughly and reposition before proceeding.
7. Do not compress springs or other elastic
objects. They could disengage hazardously.
8. Wear ANSI-approved safety goggles,
heavy-duty work gloves, and steel-toe
work boots during set up and/or use.
9. Keep bystanders out of work area.
10. 1 Ton Limit. Do not operate the Arbor
Press beyond rated capacity.
11. Inspect before every use; do not use
if parts are loose or damaged.
12. Press service must be performed only
by qualified repair personnel. Service or
maintenance performed by unqualified
personnel could result in a risk of injury.
Item 59766
SAVE THESE INSTRUCTIONS.
For technical questions, please call 1-888-866-5797.
4. Use only accessories that are identified by the
manufacturer for the specific tool model. Use of
an accessory not intended for use with the specific
tool model, increases the risk of injury to persons.
3. Use only the lubricants supplied with the
tool or specified by the manufacturer.
13. When servicing Press use only identical replacement
parts – refer to attached, product-specific parts list
and diagram. Follow instructions in the "User -
Maintenance Instructions" section of this manual.
Use of unauthorized parts or failure to follow
maintenance instructions may create a risk of injury.
14. Only use with accessories rated to handle the
forces exerted by this tool during operation. Other
accessories not designed for the forces generated
may break and forcefully launch pieces.
15. Industrial applications must follow
OSHA requirements.
16. This product is not a toy. Keep it
out of reach of children.
17. Maintain labels and nameplates on the
Arbor Press. These carry important safety
information. If unreadable or missing, contact
Harbor Freight Tools for a replacement.
18. The warnings, precautions, and instructions
discussed in this instruction manual cannot
cover all possible conditions and situations
that may occur. It must be understood by the
operator that common sense and caution are
factors which cannot be built into this product,
but must be supplied by the operator.
Page 3
Advertisement
