Advertisement
Assembly
1. Select a place on workbench to
mount the Arbor Press.
2. Purchase hardware to mount Arbor Press to
workbench. Bolt length will be the thickness of your
workbench plus 2-1/2" of length for the Body.
Figure A: Mounting Holes
3. Use the two mounting holes in Body as a template as
shown in Figure A. Mark and Drill holes in workbench.
4. Place Body over the holes on workbench
and insert the Bolts through the holes.
Thread on the Nuts and tighten.
Spring Pin (2)
Plate (3)
(Not shown)
Body
Figure B: Installing Plate
5. Place Plate (3) on base of Body as shown in
Figure B. Insert Spring Pin (2) into hole of base.
Item 59766
Body
Mounting
Holes
For technical questions, please call 1-888-866-5797.
Rack Press (4)
Body
Cover (5)
Figure C: Installing Rack Press
6. Insert Rack Press (4) down through top of Body as
shown in Figure C. Make sure teeth of Rack Press
are towards rear of Body as shown in Figure C.
Rack Teeth
Page 5
Advertisement
