Returning The Access Point To Autonomous Mode - Cisco Aironet 1130AG Series Hardware Installation Manual

Cisco Aironet 1130AG Series Access Point Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
4-8 4-8
Chapter Chapter 4 4 Troubleshooting Troubleshoo
Configuring Controller Information Configuring Controller
Note Note
Clearing Manually Entered Clearing Manually Entered Controller Information
Note Note
Manually Resetting the Access Point to Defaults Manually Resetting the Access Point to
Note Note

Returning the Access Point to Autonomous Mode

Returning the Access Point to Autonomous Mode

Hardware Installation Guide
ting Lightweig Lightweight ht Access Access Points Points
Information
To manually configure controller information on a new (out-of -the-box) access point using the access To manually configure controller information on a new (out-of -the-box) access point using the access
point CLI interface, you can use these EXEC mode CLI commands: point CLI interface, you can use these EXEC mode CLI commands:
AP# AP# < <
lwapp ap ip address lwapp ap ip address
AP# AP#
lwapp ip default-gateway lwapp ip default-gateway
AP# AP# lwapp controller ip address lwapp controller ip address
AP# AP#
lwapp ap hostname lwapp ap hostname
name name
Where Where is the access point name on the controller. is the access point name on the controller.
name name
The default (out-of-box) Enable password is The default (out-of-box) Enable password is Cisco
Controller Information
When you move your access point to a different location in your network, you must clear the manually When you move your access point to a different location in your network, you must clear the manually
entered controller information to allow your access point to associate with a different controller. entered controller information to allow your access point to associate with a different controller.
This command requires the controller configured Enable password to enter the CLI EXEC mode. This command requires the controller configured Enable password to enter the CLI EXEC mode.
To clear or remove the manually entered controller information, you can use these EXEC mode CLI To clear or remove the manually entered controller information, you can use these EXEC mode CLI
commands: commands:
clear lwapp ap ip address clear lwapp ap ip address
clear lwapp ip default-gateway clear lwapp ip default-gateway
clear lwapp controller ip address clear lwapp controller ip address
clear lwapp ap hostname clear lwapp ap hostname
You can manually reset your access point to default settings using this EXEC mode CLI command: You can manually reset your access point to default settings using this EXEC mode CLI command:
This command requires the controller configured Enable password to enter the CLI EXEC mode. This command requires the controller configured Enable password to enter the CLI EXEC mode.
clear lwapp private-config clear lwapp private-config
You can return a lightweight access point to autonomous mode by loading a Cisco IOS release that You can return a lightweight access point to autonomous mode by loading a Cisco IOS release that
supports autonomous mode (such as Cisco IOS Release 12.3(7)JA or earlier). If the access point is supports autonomous mode (such as Cisco IOS Release 12.3(7)JA or earlier). If the access point is
associated to a controller, you can use th associated to a controller, you can use th e controller to load the Cisco IO
not associated to a controller, you can load the Cisco IOS release using TFTP. not associated to a controller, you can load the Cisco IOS release using TFTP.
> < > < > >
IP address IP address subnet mask subnet mask
IP-address IP-address
IP-address IP-address
Cisco . .
Defaults
e controller to load the Cisco IOS release. If the access point is
Returning the Access Point to Autonomous Mode Returning the Access Point to Autonomous Mode
S release. If the access point is
OL-8369-04 OL-8369-04