Cisco Aironet 1130AG Series Hardware Installation Manual page 48

OL-8369-04 OL-8369-04
Attaching the Access Point to the Mounting Plate Attaching the Access Point to the Mounting Plate
St Step ep 3 3
St Step ep 4 4
St Step ep 5 5
St Step ep 6 6
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide Cisco Aironet 1130AG Series Access Point
In the cable bay area, line up the visible access point keyhole with the mounting plate keyhole clip In the cable bay area, line up the visible access point keyhole with the mounting plate keyhole clip
located near the security padlock hole (see Figu located near the security padlock hole (see
Fi Figu gure re 2-1 2-10 0 Al Alig igni ning ng th the K
2 2
3 3
1 1
Access point keyhole Access point keyhole
2 2
Mounting plate Mounting plate
3 3
Mounting plate keyhole clip Mounting plate keyhole clip
Insert the keyhole clip into the keyhole and maintain a slight pressure to hold the access point in place. Insert the keyhole clip into the keyhole and maintain a slight pressure to hold the access point in place.
Slightly rotate the access point from side-to-side until you hear the second keyhole clip falling into the Slightly rotate the access point from side-to-side until you hear the second keyhole clip falling into the
other keyhole that is located on the opposite end of the access point and is not visible. other keyhole that is located on the opposite end of the access point and is not visible.
Slide the access point back over the keyhole clips. You will hear a click when the locking detent contacts Slide the access point back over the keyhole clips. You will hear a click when the locking detent contacts
the access point and locks it into place. the access point and locks it into place.
For instructions on connecting your cables, refer to the "Connecting the Ethernet and Power Cables" For instructions on connecting your cables, refer to the
section section on on pag page e 2-22. . 2-22
For instructions on securing your access point, refer to the "Securing the Access Point" section on For instructions on securing your access point, refer to the
pag page e 2-1 2-19 9 . .
Hardware Installation Guide
Figure re 2-10 2-10). ).
e Key eyho hole le Cl Clip ip to to th the A e Acc cces ess P s Poi oint
1 1
5 5
4 4
4 4
5 5
"Connecting the Ethernet and Power Cables"
Chapter 2 2 Chapter Installing Installing the
nt Ke Keyh yhol ole e
8 8
8 8
8 8
1 1
2 2
1 1
Security screw hole Security screw hole
Padlock hole Padlock hole
"Securing the Access Point" section on
2-17 2-17
the Access Access Point Point