Alarm setting
If the alarm is switched on, the door opera-
tor beeps if the door is open for longer than
10 minutes. The door operator beeps for 30
seconds every 10 minutes.
1. Press „P" for
approx. 5 seconds.
4. Press „+",
the display is „1" .
(1 = on = the alarm setting is
switched on)
Automatic closing time setting
NOTE
Before the door closes automati-
cally, the door operator beeps for
20 seconds. At the same time the
light flashes.
When the door starts closing, the
light shines durably and it beeps
permanently.
After the door has closed, the
door operator ends the beeping
and the light remains on for a
further 3 minutes.
2. Press „+"
(press several times if necessary)
until „5" is displayed.
5. Press „P" in order to
store the alarm setting.
1. Press „P" for
approx. 5 seconds.
3. Press „P",
the display is „0".
(0 = off = factory setting)
To end the beeping:
Press the door control button to fully close the door.
3. Press „P",
the display is „0".
(0 = off = factory setting)
6. Conclude programming
(refer to page 27, method 2)
or proceed with next setting.
2. Press „+"
(press several times if necessary)
until „6" is displayed.
4. Press „+",
the display is „1".
(1 = on = automatic closing
time = 30 seconds)
EN
25