(D) Installation Of The Middle Support Clip (13); (E) Installation On The Ceiling With Perforated Brackets - RADEMACHER RolloPort S2 Translation Of The Original Operating And Assembly Manual

(C) Installation of the door bracket (8)
3. Screw the door bracket (8) tight with
the enclosed self-tapping hexagon screws
(8 x 15 mm).
Finally, fix the door connector (12) to the
4.
door bracket (8) with the enclosed bolt (9).
NOTE
A straight door connector is supplied pre-assembled,
and this is permanently fixed to the rail.
If you wish to use the bent door connector (12)
enclosed (depending upon your door particular configu-
ration), you must attach this with two hexagon screws
(8 x 20) to the straight door connector.
5. Finally, secure the bolt (9) by attaching the se-
curing bolt (11) to prevent it from slipping out.

(D) Installation of the middle support clip (13)

1. Fit the middle support (13) clip at a suitable
place, as near as possible to the middle point
between the door and the door operator head.
Key
13 = Middle support clip
14 =
Hexagon screws (8 x 60 mm)

(E) Installation on the ceiling with perforated brackets

If mounting directly on the ceiling is not possible due to the
ceiling height being too high, the perforated brackets must
be used for the suspension because there is a distance of
more than 25 cm between the highest point of the door
and the rail.
To do this, bend the brackets to the desired length and
then connect them to the mounting bracket and the
centre suspension.
20
13
14
(E)
EN
9