Adjust Power Limiting As Required - RADEMACHER RolloPort S2 Translation Of The Original Operating And Assembly Manual

Adjust power limiting as required

NOTE
The door operator is preset to stage 3 by the supplier.
If required (e.g. if the power level is too low) you can
subsequently adjust the power limiting setting.
1. Press „P" for
approx. 5 seconds.
4. Press „+" or press „-"
to select the stage.
5. Press „P", in order
to store the setting.
After a resetting of the power level, it is absolutely necessary to repeat the reference run for power
limiting and to conclude the programming again.
◆ During the reference run there is a risk of injury as the door operator develops
extremely strong forces.
◆ If the subsequent adjustment does not restore correct operation, please contact our authorised
Service department.
24
2. Press „+"
(if necessary press several times)
until „4" is displayed.
Low
Factory setting
6. IMPORTANT
Repeat reference run
for power limiting
(refer to page 23).
If the power level is too low, the door move-
ment will be impaired, particularly if the
mechanical structure of the door is not well
balanced.
3. Press „P", the display
shows „7" (stage 3).
Power level
7. Conclude programming
(refer to page 27,
method 1).
EN
High