Take Measurements - RADEMACHER RolloPort S2 Translation Of The Original Operating And Assembly Manual

Take measurements

1. Measure up and mark the centre of the door
Mark the centre of the door, as shown, on the upper
edge of the door, on the door lintel and on the garage
ceiling.
2. Determine the distance between the top edge
of the door and the ceiling
Close the door slowly and measure the distance between
the top edge of the door and the ceiling.
NOTE
The minimum distance should be 6 cm.
3. Installation advice for fitting to sectional
doors
If the garage door operator is used for a sectional door,
then the guide roller of the upper door segment must be
in the bend of the guide rail when the door is closed.
14
up-and-down
door
sectional
door
Right
min. 6 cm
min. 6 cm
✗
Wrong
EN