(C) Installation Of The Door Bracket (8) - RADEMACHER RolloPort S2 Translation Of The Original Operating And Assembly Manual

(C) Installation of the door bracket (8)

NOTE
We recommend fixing the door bracket (8) to the door
frame if possible.
For plastic or thin-walled wooden doors, additional cross-
beams are necessary in order to avoid damaging the door.
In this case, consult your door supplier.
Use existing drillholes, if possible, to mount the door
bracket (8).
1. Place the door bracket (8) on the top edge
of the garage door and align it with the centre
of the door (in a line with the profile slide).
Next, mark out the four fixing holes on the
door frame.
2. Punch in the fixing holes in the door frame
with the aid of the enclosed spike
NOTE
Self-tapping screws need sufficient hold in the mate-
rial. Check the thickness of your door frame. If it is
sufficiently thick you can also pre-drill the fixing holes
with a 4 mm metal drill bit if you are not able to punch
in the holes with the spike.
8
9
10
Key
8
= Door bracket
9
= Bolt (8 x 20 mm)
10 =
Self-tapping hexagon screw (6 x 15 mm)
11 = Securing bolt (2 x 20 mm)
12 =
Door connector, bent
RIGHT
Fixing hole made
using spike
The screw has
sufficient hold
EN
11
12
WRONG
Fixing hole made
by drilling
The screw does not
have sufficient hold
19