Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Sartorius Stedim Biotech Palletank
Summary of Contents for Sartorius Stedim Biotech Palletank
- Page 1 User Manual ® Palletank For Shipping 85037-551-72...
-
Page 2: Table Of Contents
Shipping are composed of a single-use Palletank ® For Shipping – ® sterile bag (the Flexsafe 3D bag or Unfolding and folding Flexel ® 3D bag) and the Palletank ® instructions Shipping rigid container. The stainless 2.1. Unfolding ® steel constructed Palletank for Shipping 2.2. -
Page 3: Unfolding
® 2. Palletank For Shipping – Unfolding and folding instructions 2.1. Unfolding a) Starting from the folded Palletank ® (See Fig. 1), remove all the components from inside the Palletank ® base (See Fig. 2) and from the bottom compartments: –... -
Page 4: Folding
® base, insert the Shipping kit foam pad (See Fig. 9) and steel plate (See Fig. 9 and 10). b) The dunnage foams should be packed in a polybag prior to being stored in the Palletank ® bottom compartment. Fig. 9... - Page 5 ® panels: ® – Hold the first panel with the locking systems visible and position it in the Palletank (See Fig. 13). The two holes on the side of the panel will fit into the two slots on the ®...
-
Page 6: Preparation Prior To Shipping Kit Installation
3D is filled to its nominal volume – The filled Flexsafe ® | Flexel ® 3D bag is correctly positioned in the Palletank ® for Shipping (the bag corners must be aligned with the container angles) – There are no folds on the bag –... -
Page 7: Shipping Kit Installation
Slightly unscrew the two nuts of the gripping plate and slid it open. Fig. 22 d) Hold the steel plate with the two handles and position it over the foam plate while inserting the bag tubes through the opening near the Palletank ® front panel (See Fig. 23). - Page 8 4 clamping screws prior to assembling the locking levers. Fig. 27 ® j) Insert the blocking bars ends in the Palletank front and back panel holes. Start by inserting the bar extremities in the container front panel then in the rear panel (See Fig. 28).
-
Page 9: Shipping Kit Removal
7. Precautions of use instructions Caution ® ® ® a) In order to remove the Palletank a) The Flexsafe | Flexel 3D System for Danger of corrosion and damage to Shipping Kit at the shipping destination, Shipping is designed for the transport of stainless steel Palletank ®... -
Page 10: Disclaimers
Sartorius Stedim instructions for use and precautions of use, Biotech specifications will apply. shall apply. b) Sartorius Stedim Biotech will not be held responsible if the “Palletank ® For Shipping User Manual” as described in this docu- ment are not strictly followed and the above mentioned Precautions of Use applied. - Page 11 No part of this publication may be reprinted or translated in any form or by any means without the prior written permission of Sartorius Stedim Biotech GmbH. The status of the information, specifications and illustrations in this manual is indicated by the date given below.
Need help?
Do you have a question about the Palletank and is the answer not in the manual?
Questions and answers