Table of Contents
Advertisement
Machine Setup
31
2.5.4
High Speed Engraving Spindle
The High Speed Engraving Spindle is installed with the High Frequency Router Motor. It allows up to a
30,000 RPM spindle speed. Connections to the machine's Controller are the same as when only using
the High Frequency Router Motor.
High Speed Engraving Spindle Installation
1. Remove the Collet Nut and Collet from the bottom of the Router Motor.
2. Install the Drive Pulley on to the threaded portion of the Motor Shaft and secure with the provided
wrenches.
© 2019 Vision Engraving & Routing Systems
Advertisement
Table of Contents
