Table of Contents
Advertisement
20
Vision 1624R, 2525 and 2550 Series 5 Installation Guide
Engraving Head Removal Procedure
1. Remove the Motor Plug from the back of the Carriage and place it over the Cable/Hose Hanger.
2. Loosen the four mounting screws and remove. The Engraving Head will be held in place on the Rail
Plate by the two Dowel Pins on the back of the Mounting Plate.
3. Using two hands, pull the Engraving Head away from the Rail Plate.
To Install the Engraving Head, reverse this procedure.
© 2019 Vision Engraving & Routing Systems
Advertisement
Table of Contents
