30
Fishfinder cable
The fishfinder cable is supplied with your Digital Sounder Module (DSM). This cable
should be run and connected to the rear of the display.
DSM 250
A terminator must be fitted to the cable at the DSM 250:
• 10m cable - E05016
• 3m cable - E65009
DSM 300
No terminator is required for connection to a DSM 300:
• 3m cable - E65010 (supplied with the DSM 300)
• 10m cable - E65011 (accessory)
Radar cable (not supplied)
Having ensured that the radar scanner you are using is compatible with the C-Series
Display (see page
Connecting a radome
If you are using a radome this can be powered through the display.Run your cable and
connect it to the radome and the display.
Note:
In this configuration significant current passes through the power cable. Any extension
should be as short as possible using a large wire gauge.
Length - 3m or 10m
page 13
), the cable should be connected as follows:
Radome
Display
C-Series Displays Installation Manual
PAGE
ACTIVE
WPTS/
MOB
DATA
MENU
OUT
RANGE
IN
OK
CANCEL
In-line terminator
D6908_2
Boats DC
Power Supply
D6619-3