Adjusting The Bearing Alignment; Checking The Gps - Raymarine C120 Installation Manual

Chapter 4: Commissioning the system

Adjusting the bearing alignment

1. If moored, move the EBL to calculate bearing.
2. With a radar application in the active, press MENU. The Set Up menu is displayed.
3. With RADAR SET UP highlighted, use the trackpad (right) to display the RADAR SET
UP menu.
4. Use the trackpad (up/down) to highlight and then the trackpad (right) to select
BEARING ALIGNMENT. The menu is removed from the screen and the Bearing
Alignment soft key is displayed.
5. Press the BEARING ALIGNMENT softkey.
6. Proceed as follows:
• If the boat is moored - use the rotary control to place the selected target
• If the boat is under way - use the rotary control to place the selected target
7. Press OK. The picture updates as the bearing alignment is adjusted.
8. To exit the menu, press OK or CANCEL.

Checking the GPS

The GPS is used to position your boat on the chart. You can set up your Global
Positioning System (GPS) and check its status using the GPS status icons and the GPS
Status page of the Setup menu.
To access the GPS Status page:
1. Press MENU. The Setup menu is displayed.
2. Highlight and then select GPS Status. The GPS Status dialog box is displayed e.g.
DIFF GPS
ON
under the EBL.
under the SHM.
SD-FIX
00001.0
OFF
122
HDOP FIX STATUS
SATELLITE DIFFERENTIAL
WGS 1984
DIFF SET UP OTHER SET UP
0
0
0
0
0
0
0
0
0
0
0
0
RESTART GPS
D6809_2
39