Assembly - ICON Health & Fitness Pro-Form Trainer 5.0 User Manual

ASSEMBLY

• To hire an authorized service technician to
assemble the treadmill, call 1-800-445-2480.
• Assembly requires two persons.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you fi nish all assembly steps.
• After shipping, there may be an oily substance
on the exterior of the treadmill. This is normal. If
there is an oily substance on the treadmill, wipe
it off with a soft cloth and a mild, non-abrasive
cleaner.
1. Go to my.proform.com on your computer and
register your product.
• documents your ownership
• activates your warranty
• ensures priority customer support if assistance
is ever needed
Note: If you do not have internet access, call
Customer Care (see the front cover of this
manual) and register your product.
2. Make sure that the power cord is unplugged.
Carefully raise the Right Upright (70) to the verti-
cal position.
Next, start an M10 x 58mm Screw (1) and an
M10 x 25mm Screw (2) into the Base (74) and
the Right Upright (70) as shown; start both
Screws, and then tighten them.
Repeat this step on the left side of the
treadmill.
• Left parts are marked "L" or "Left" and right parts
are marked "R" or "Right."
• To identify small parts, see page 7.
• Assembly requires the following tools:
the included hex keys
one Phillips screwdriver
To avoid damaging parts, do not use power tools.
1
2
8
70
1
2
74