Assembly - ICON Health & Fitness NTL24012.2 User Manual

ASSEMBLY

•• Assembly requires two persons.
•• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you  nish all assembly steps.
•• After shipping, there may be an oily substance on
the exterior of the incline trainer. This is normal.
If there is an oily substance on the incline trainer,
wipe it off with a soft cloth and a mild, non-abra-
sive cleaner.
•• Left parts are marked “"L”" or “"Left”" and right parts
are marked “"R”" or “"Right.”"
1. Make sure that the power cord is unplugged.
Identify the right Upright (77), which has a wire
tie in it. Hold the right Upright near the right side
of the incline trainer.
See the inset drawing. Tie the wire tie in the
right Upright (77) around the end of the Upright
Wire (78). Then, pull the other end of the wire tie
until the Upright Wire is routed through the right
Upright.
•• To identify small parts, see page 6.
•• Assembly requires the following tools:
the included hex keys
Phillips screwdriver
To avoid damaging parts, do not use power tools.
1
Wire
Tie
78
77
7
Wire
Tie
77
78