Table of Contents
Advertisement
Chapter 2
Installing the Device
2.
Mount the device.
3.
Set the operating mode.
4.
Connect power to the device and ground the device to safety Earth.
5.
Connect the device to the network.
6.
Configure the device.
Section 2.2
Unpacking the Device
When unpacking the device, do the following:
1.
Inspect the package for damage before opening it.
2.
Visually inspect each item in the package for any physical damage.
3.
Verify all items are included.
IMPORTANT!
If any item is missing or damaged, contact Siemens for assistance.
Section 2.3
Mounting the Device
The RUGGEDCOM RMC41 is designed for maximum mounting and display flexibility. It can be equipped with
connectors that allow it to be installed in a 35 mm (1.4 in) DIN rail or directly on a panel.
IMPORTANT!
Heat generated by the device is channeled outwards from the enclosure. As such, it is recommended
that 2.5 cm (1 in) of space be maintained on all open sides of the device to allow for some
convectional airflow.
Forced airflow is not required. However, any increase in airflow will result in a reduction of ambient
temperature and improve the long-term reliability of all equipment mounted in the rack space.
NOTE
For detailed dimensions of the device with either DIN rail or panel hardware installed, refer to
Section 4.7, "Dimension
CONTENTS
•
Section 2.3.1, "Mounting the Device on a DIN Rail"
•
Section 2.3.2, "Mounting the Device to a Panel"
6
Drawings".
RUGGEDCOM RMC41
Installation Guide
Unpacking the Device
Advertisement
Table of Contents
