Trouble Shooting - Simpson SWT7055LMWA User Manual

9.

TROUBLE SHOOTING

DO NOT call for service until you have checked the points listed below.
If you call for service and there is nothing wrong with your washing machine, you will
have to pay for the service call.
You will have to pay even when your washing machine is under warranty. Before you
call for service, check the points in the table below.
Problem Display
Code
Machine not
working.
EF0
Machine has
EF0
washed load
but will not
spinning.
Water in wash
bowl.
Will not fill
with water.
Water flowing
into wash
bowl
indefinitely.
Machine goes
out of balance
or vibrates EF0
excessively
when spinning.
Water on floor.
Water splash.
Possible Causes
Power not switched on.
No electricity supply through
the power point.
Water taps not turned on.
Out of balance detected.
Lid not fully closed.
Out of balance.
Lid not fully closed.
Drain hose blocked.
Water taps not turned on.
Inlet hoses blocked.
Drain hose too low.
Machine not levelled.
Levelling feet not adjusted.
Clothes not evenly distributed.
Loose inlet hose connections.
Loose drain hose connections.
Machine not levelled.
Water Level selection not
correct.
What to do
Switch on power point.
Check power point with
another appliance.
Turn on taps.
Open lid, redistribute load and
close lid.
Close lid.
Open lid, redistribute load,
close lid.
Close lid.
Check drain hose for blockage.
Wait a short while, press start
to continue.
Turn taps on.
Clean inlet hose filters.
Raise drain hose or fit a
syphon break.
Refer to installation instructions
for correct positioning of hose.
Level the machine properly.
Adjust feet to touch the floor.
Redistribute clothes evenly.
Check connections at taps and
rear of machine.
Check connections at rear of
machine.
Level the machine properly.
See water level description
on page 9.
27