Simpson SWT7055LMWA User Manual page 12

12
3.6 DISPLAY
The display shows the following
information:
Machine In Pause Mode
Time digits and colon LEDs at rate
of 1s.
Estimated time of the
selected program
After selecting a program, the
estimated time is displayed in hours
and minutes (for example 1.05).
The estimated time is calculated
automatically on the basis of the
maximum recommended load for
each program. After the program
has started, the time remaining is
updated every minute.
End Of Program
When the program is completed
display show will show "End".
Alarm Codes
In the event of operating problems,
some alarm codes can be
displayed, for example
"Troubleshooting" and
"Troubleshooting fault displays" on
page 26, 27, 28).
Stand by/ Auto off
Incorrect Option Selection
Blink
Blink
(see
Colon ":" LED
lights up,Static.
If an option is not compatible with
selected program, display will flash
"---" with 3 consecutive short
beeps.
3.7 START/PAUSE BUTTON
To start the selected program,
press the "Start/Pause" button.
If you have started your wash and
you wish to stop it for some reason,
press the "Start/Pause" button to
enter PAUSE mode. To restart the
program from the point at which it
was interrupted, press the
"Start/Pause" again.
If the lid has been opened any
time during operation of the
machine, the Start/Pause
button has to be pressed when
the lid is closed to continue
operation.
3.8 DELAY END OPTION
BUTTON
(SWT6055TMWA,SWT7055TMWA
,SWT7055LMWA)
Before you start the program, this
option makes it possible to delay the
end of the washing program by 2, 4,
6, 8, 10 or 12 hours, by pressing
Delay End button to choose the end
time as your wish. This option must
be selected after choosing the wash
program, and before pressing the
"Start/Pause" button. If after having
set the Delay-End option (and
pressed "Start/Pause" button) and
you wish the cancel or modify it,
follow the below steps:
-
set the washing machine to
PAUSE by press "Start/Pause"
button;
- deselect the Delay-End option,
changing the status;
- press the "Start/Pause" to start
the program.