Table of Contents
Advertisement
Lightcloud Devices
Lightcloud devices that are mains hard-wired powered are designed
to be installed on a junction box or similar enclosure, and must be
installed by a qualified electrician. Refer to your device's manual for
installation considerations and best practices.
Lightcloud Device Table
The Device Table is essential for referencing during setup or for troubleshooting—don't forget it! Two copies are
provided: one to keep near your Gateway, and one for the building owner or facility manager to file.
I N T H E B OX
PANEL/
DEVICE ID
ZONE NAME
PWR/ENGY
DIM
NOTES
CIRCUIT #
M O U N T I T
Mount device table to breaker box.
TIP:
stickers on or near your
devices or circuits for
easier identification.
H OW TO U S E I T
Place Gateway ID sticker at the top.
G ATE WAY ID :
if a zone uses the Controller's
:
PWR/ENGY
integrated power monitoring, place a
checkmark.
if a zone uses the Controller's 0-10V
:
DIM
dimming wires, place a checkmark here.
Lightcloud Devices and Table
Use extra Device ID
17
Advertisement
Table of Contents
