RAB Lighting ALED 52W Installation Instructions

®
ALED 52W INSTALLATION INSTRUCTIONS
Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We'd like to hear your comments.
Call the Marketing Department at 888-RAB-1000 or email: marketing@rabweb.com
ALED52
Standard (15 Deg)
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
RAB fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding
is required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A
PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNING: Make certain power is OFF before installing or maintaining fixture. No user serviceable parts inside.
MOUNTING ALED52 TO POLE
Mount directly to 4" or larger square steel pole. Do not separate Pole Arm from Housing.
1. Remove Pole Arm Cover Plate by loosening two screws.
2. Place Pole Gasket between the Pole Arm and drilled Pole as shown. Line up center hole with center hole in the pole drilling
pattern.
3. Insert 3/8-16 x 1 1/4" Bolts from the Pole Arm thru the top hole of the Pole and thread into the Bolster Plate. Longer 2 1/4"
bolts provided for use with round pole and round pole adaptor. For PAD4 applications use bolts, nuts, lockwashers and
washers and tighten inside the PAD4. Do not use bolster plate.
4. Knot wires in pole for strain relief and feed wires from the pole into the Pole Arm. Make the necessary wiring connections in
the Pole Arm.
5. Install the Arm Gasket on to the Pole Arm Cover Plate and secure it with the screws. Cover the screws with provided caps.
Install the Pole Cap.
Arm Gasket
Housing
Pole Arm Cover
Plate
ALEDC52
Cutoff (7.5 Deg)
Pole Arm
Bolts, Washer and
Lockwasher
ALEDFC52
Full Cutoff (0 Deg)
Pole Cap
Pole Gasket
Bolster Plate