Table of Contents
Advertisement
TM
FALCOR INSTALLATION INSTRUCTIONS
Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We'd like to hear your comments.
Call the Marketing Department at 888-RAB-1000 or email: marketing@rabweb.com
WIRING
WIRING
Universal voltage driver permits operation at 120V thru
Universal voltage driver permits operation at 120V thru
277V, 50 or 60 Hz. Units ordered with (/480V) suffix are
277V, 50 or 60 Hz. Units ordered with (/480V) suffix are
480V.
480V.
1. Connect the black fixture lead to the LINE
1. Connect the black fixture lead to the LINE
supply lead.
supply lead.
2. Connect the white fixture lead to the COMMON
2. Connect the white fixture lead to the COMMON
supply lead.
supply lead.
3. Connect the GROUND wire from fixture to
3. Connect the GROUND wire from fixture to
supply ground.
supply ground.
0-10V DIMMABLE WIRING
Universal voltage driver permits operation at 120V thru 277V,
50 or 60 Hz. For 0-10V Dimming, follow the wiring directions
as in Fig. 5.
1. Connect the black fixture lead to the LINE supply lead.
2. Connect the white fixture lead to the COMMON supply
lead.
3. Connect the GROUND wire from fixture to supply ground.
Do NOT connect the GROUND of the dimming fixture to
the output.
4. Connect the purple fixture lead to the (V+) DIM lead.
5. Connect the gray fixture lead to the (V-) DIM lead.
6. Cap the yellow fixture lead, if present. Do NOT connect.
Note: These instructions do not cover all details or variations in equipment nor do they provide for every possible situation during installation
operation or maintenance.
Easy Installation & Product Help
Tech Help Line
©2015 RAB LIGHTING Inc.
Call our experts 888 RAB-1000
Northvale, New Jersey 07647 USA
FALCOR-FALCORA-IN-0915
GUARD OR SHIELD INSTALLATION
Wire Guard and Poly Shield mount with (4)
Stainless Steel Screws. Screws are provided with the
accessory. See Fig. 6 for Guard. See Fig. 7 for Shield.
1. Line up guard or shield with existing pre-drilled holes in
frame as shown, tighten screws.
Fig. 6
Fig. 4
Fig. 7
CLEANING & MAINTENANCE
CAUTION: Be sure fixture temperature is cool enough to
touch. Do not clean or maintain while fixture is energized.
1. Clean glass lens & fixture with non-abrasive glass
cleaning solution.
2. Do not open fixture to clean the LED. Do not touch the
LED.
TROUBLESHOOTING
1. Check that the line voltage at fixture is correct. Refer to
Fig. 5
wiring directions.
2. Is the fixture grounded properly?
ACCESSORIES
Wire Guard:
Poly Shield:
rabweb.com
Visit our website for product info
Housing
Wire Guard
Screws (4)
GDFALCORW
GDFALCORP
email
Answered promptly sales@rabweb.com
Housing
Poly shield
Screws (4)
Advertisement
Table of Contents
