Size Setting Mode For Series Gwl11 / Iwl12 / Iwl15; Size Setting - Gw - Fisher & Paykel IWL12 Service Manual

517766B
15. SIZE SETTING MODE FOR SERIES GWL11 / IWL12 /
IWL15
15.1 Size setting – GW
The difference between the GW Series 11 and previous GW machines is the position of
the Power button. The sequence for sizing the modules is the same.
It is important to set the size switch setting into the Motor Controller's memory whenever a
replacement Motor Controller and or IW Display Module is fitted to SmartDrive. Failure to
do this will result in SmartDrive faulting with fault code 9 (Size switch error).
Accessing size setting mode is the best way to check the size for GW. The size setting of
SmartDrive may be checked in Diagnostic mode for all phases.
To set the size switch turn the power on at the power point and off at the console. Press
and hold the TEMPERATURE UP button then press the POWER button. SmartDrive will
give 4 short beeps and the pattern of LEDs will change.
• Press SPIN SPEED UP button, the SPIN HOLD LED is on for (8.0kg) 17.6lb (650mm
wide). 25.5 in
• Press POWER to exit this mode.
If the size setting is wrong SmartDrive will have the following settings incorrect: -
• The Auto Water Levels chosen by SmartDrive may be wrong.
• The High Water Level may be wrong by as much as 1.5 in.
• The flow rate for inlet water, normally (3 litres or 0.8 gal per minute), may be set
incorrectly.
• The wash profile controls the strength of the agitator. This could result in poor wash
performance or splash over.
• Water saver settings.
- 12 -
May 2004