Table of Contents
Advertisement
Tap 2
Eg: 30% battery remaining
Tap 3
Eg: Right chamber
activated 3 days ago
Tap 4
Cycles Interface back to Battery Level screen. At any point during these Taps, opening a
tray will Enter Service Mode and exit Status Check.
2. Enter Service Mode
NOTE: The interface display must be active before entering service mode.
You are only required to enter Service Mode if there is an error shown on the
interface display, or if a tray is visibly damaged and needs replacing. See
previous section (1. Status Check).
1.
When the Interface is active open one of the two catch trays. This will access service
mode.
Second tap using the RI Magnet Key, will display Battery
Level (Icon
) along with the percentage of battery level.
Third tap using the RI Magnet Key, will display Catch
Duration (Icon
) along with the left Arrow Status icon and
number of days since the left hand side triggered. This will
be shown for 2 seconds before the right Arrow Status icon
and number of days since the right hand side triggered is
shown.
2.
17
Advertisement
Table of Contents
