Table of Contents
Advertisement
4. Battery Level
5. Site Survey
To assess network signal strength and the number of control panels required for a
site, the Range Check Mode can be used.
With the device Interface active, hold the
for 3 seconds and Range Check Mode will be enabled. The user interface LEDs will
show this and give a reading r- to r9. Higher the "r" number, the stronger the signal.
The signal strength will show for 1 hour to allow technician to survey the site.
The Connect LED Identifier (Icon
LED IDENTIFIER:
To exit the Range Check Mode before the 1 hour duration, hold the RI Service Key
Magnet over the sensor for 3 seconds. When in Range Check Mode, a tap of the
Service Key Magnet will go into System information (see page 25).
6. Open Catch Tray
1.
Battery capacity % displayed for 2 seconds with
Battery Level (Icon
Eg: Battery is at 99%
(Connect Variants Only)
RI Service Key Magnet
) will also flash to indicate signal strength:
Flashes Purple:
Trying to connect
Flashes Red:
No signal
2.
13
) solid.
over the sensor
Flashes Yellow:
Weak signal
Flashes Blue:
Good signal
Advertisement
Table of Contents
