Adjusting The Steering Head Bearing Play; Lubricating The Steering Head Bearing - Husqvarna FC 450 2019 Owner's Manual

11.12

Adjusting the steering head bearing play

11.13

Lubricating the steering head bearing

SERVICE WORK ON THE CHASSIS 11
Preparatory work
–
Raise the motorcycle with a lift stand. (
–
Remove the handlebar cushion.
Main work
–
Loosen screws
–
Remove screw
–
Loosen and retighten screw
Guideline
Screw, top steering
head
–
Using a plastic hammer, tap lightly on the upper triple clamp
K01111-10
to avoid stresses.
–
Mount and tighten screw
Guideline
Screw, top
steering stem
–
Tighten screws
Guideline
Screw, top triple
clamp
–
Check the steering head bearing play. (
Finishing work
–
Mount the handlebar cushion.
–
Remove the motorcycle from the lift stand. (
–
Remove the lower triple clamp.
–
Install the lower triple clamp.
Info
The steering head bearing is cleaned and lubricated
in the course of removal and installation of the lower
triple clamp.
H02387-01
https://www.motorcycle-manual.com/
p. 49)
1
.
2
.
3
.
M20x1.5 12 Nm (8.9 lbf ft)
2
.
M8 20 Nm (14.8 lbf ft)
1
.
M8 17 Nm (12.5 lbf ft)
p. 56)
( p. 53)
( p. 54)
®
Loctite 243™
p. 49)
57