Husqvarna FC 450 2019 Owner's Manual page 99

–
Manually press the brake caliper to the brake disc to push
back the brake piston. Ensure that brake fluid does not
flow out of the brake fluid reservoir, extracting it by suc-
tion if it does.
Info
Make sure when pushing back the brake piston
that you do not press the brake caliper against the
spokes.
H00324-10
–
Remove the cotter pins
the brake linings.
–
Clean the brake caliper and brake caliper support.
–
Check that leaf spring
6
plate
Info
The arrow on the leaf spring points in the rotation
direction of the brake disc.
H00326-10
–
Insert the new brake linings, insert pin
cotter pins
Info
Always change the brake linings in pairs.
Make sure that decoupling plate
on the piston side brake lining.
–
Operate the foot brake lever repeatedly until the brake
linings are in contact with the brake disc and there is a
H00327-10
pressure point.
–
Add brake fluid to level
Brake fluid DOT 4 / DOT 5.1 (
–
Mount and tighten screw cap
the O-ring.
Info
Clean up overflowed or spilled brake fluid immedi-
ately with water.
K01106-10
(FX 450)
–
Stand the vehicle upright.
–
Remove the cable ties on the frame protector.
–
Remove screw cap
V01358-10
https://www.motorcycle-manual.com/
BRAKE SYSTEM 12
3
, pull out pin
5
in the brake caliper and sliding
in the brake caliper support are seated correctly.
3
.
A
.
p. 145)
1
with membrane
1
with membrane
4
, and remove
4
, and mount the
7
is mounted
2
and
2
and the shim.
97