Table of Contents
Advertisement
10-24. Test Run Procedure
Recheck the items to check
before the test run.
Check the combination (wiring) of
indoor and outdoor units.
YES
Is system "single-type"?
(1 indoor unit is connected
to 1 outdoor unit)
Turn ON
Are multiple outdoor units
the indoor
and outdoor
power.
(Automatic
Address)
(See 10-26-2) How to Set the Outdoor
Unit System Address
Set the outdoor unit system
address.
(See 10-26-1, 2) How to Set Automatic
Address
Set the automatic address
setting from outside unit.
Indicate (mark) the
combination number.
Set the indoor unit control
unit to "TEST".
operation be
Turn the power back ON to
the indoor unit.
Big_PAC_eng.indb 64
Big_PAC_eng.indb 64
(See 10-11)
(See 10-26-1)
NO
NO
used?
YES
Turn ON
the indoor
and outdoor
power.
(Automatic
Address)
(See 10-26-3, -4)
(See 10-26-3)
(See 10-25)
Refer to "Table of
NO
Can
Self-Diagnostic
Functions" to check
started?
the system.
In addition, refer to
10-26 and correct any
items that need to be
corrected.
YES
Note: Check the indoor-
side drainage.
(See 10-13)
Fig. 10-22
64
2009/08/26 16:33:25
2009/08/26 16:33:25
Advertisement
Table of Contents
