Using your telephone
2.30.2 Join a 'Meet me' conference
Once set-up by the conference initiator, other participants can join the 'Meet me' conference.
Enter the joining code for the 'Meet me' conference. This code is defined by the
•
administrator during system configuration. If necessary you may need to contact your
administrator.
Enter the conference access code.
•
Conference access code: 'x' digits code defined by the conference master and communicated
to the participants so that they can join the conference.
You are in conference mode.
•
An audible beep rings when a participant joins the conference.
You cannot join a conference if there are already the maximum number of participants.
If you cannot directly reach the conference, you have to call first an internal user or an Attendant
Set. This one dials the call number for joining the 'Meet-me ' conference and then transfers your
call (10 seconds).
2.31 Intrusion into an internal conversation (barge-in)
Your contact's line is busy. If the number is not 'protected' and if authorised, you can intrude into
the call:
Intrusion
•
Same key to exit (Intrusion).
•
2.31.1 Protect a call against intrusion
Press programmed key. The programmed key has to be configured by the system:
•
intrusion (No
intrud) (by default).
Enter contact's number.
•
Protection is cancelled when you hang up.
2.32 Signal malicious calls
This key lets you signal a malicious call. If this call has an internal source, it is signalled to the
system by a special message.
You receive a malicious call.
•
Malicious
•
8AL90399ENAD ed01
No
52/141