Adjusting Steering Head Bearing Play; Lubricating The Steering Head Bearing - Husqvarna FC 250 2023 Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.12
11.13
56

Adjusting steering head bearing play

A10214-10

Lubricating the steering head bearing

H02387-01
Preparatory work
–
Raise the motorcycle with a lift stand. (
–
Remove the handlebar cushion.
Main work
–
1
Loosen screws .
–
2
Remove screw .
–
Loosen and retighten screw
Guideline
Screw, top steering
head
–
Using a plastic hammer, tap lightly on the upper triple clamp
to avoid stresses.
–
1
Tighten screws .
Guideline
Screw, top triple
clamp
–
Mount and tighten screw
Guideline
Screw, top M8
steering stem
Finishing work
–
Check the steering head bearing play. (
–
Remove the motorcycle from the lift stand. (
–
Mount the handlebar cushion.
–
Remove the lower triple clamp.
–
Install the lower triple clamp.
Info
The steering head bearing is cleaned and lubricated
in the course of removal and installation of the lower
triple clamp.
p. 48)
3
.
M20x1.5 12 Nm (8.9 lbf ft)
M8 17 Nm (12.5 lbf ft)
2
.
20 Nm (14.8 lbf ft)
Loctite
p. 55)
p. 48)
( p. 52)
( p. 53)
®
243™