Husqvarna FC 250 2023 Owner's Manual page 95

–
Insert the new brake linings, insert pin
4
pins .
Info
Always change the brake linings in pairs.
Make sure that decoupling plate
the piston side brake lining.
–
Operate the foot brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
F03723-10
point.
–
Correct brake fluid level to marking
Brake fluid DOT 4 / DOT 5.1 (
–
Mount and tighten screw cap
O-ring.
Info
Use water to immediately clean up any brake fluid that
has overflowed or spilled.
A01083-10
–
Insert the right frame protector from below and push it to the
rear.
–
Mount and tighten screw
Guideline
Screw, frame pro-
tector
–
Mount the new cable ties.
A01180-10
Finishing work
–
Install the right side panel. (
BRAKE SYSTEM 12
5
, and mount cotter
8
is mounted on
A
.
p. 139)
2 3
with membrane
1
with washer.
M5 3 Nm (2.2 lbf ft)
p. 67)
and the
93