Microsoft General Troubleshooting Of Windows Bug Check Codes; Use Windows Debugging Tool - HP Z VR Backpack G1 Maintenance And Service Manual

Microsoft general troubleshooting of Windows bug check codes

● If you recently added hardware to the system, try removing or replacing it. Or check with the manufacturer
to see if any patches are available.
● Try running HP PC Hardware Diagnostics (UEFI).
Check with the manufacturer to see if an updated system BIOS or firmware is available.
●
● Be sure that any expansion board is properly seated and all cables are completely connected.
● Confirm that any new hardware that is installed is compatible with the installed version of Windows.
● If new device drivers or system services have been added recently, try removing or updating them.
NOTE:
required drivers and system services during the Windows startup. To enter safe mode, restart your
computer and press
Advanced Options menu, choose Safe Mode.
● Run a virus detection program. Viruses can infect all types of hard drives formatted for Windows, and
resulting drive corruption can generate system bug check codes. Be sure that the virus detection program
checks the Master Boot Record for infections.
Verify that the system has the latest service pack installed. To detect which service pack, if any, is installed
●
on your system, click Start, click Run, type winver, and then press Enter. The About Windows dialog box
displays the Windows version number and the version number of the service pack, if one has been
installed.
● Disable BIOS memory options such as caching or shadowing.
● Check the System Log and Application Log in Event Viewer to see if any additional error messages have
been logged recently. These might pinpoint the cause of the error.

Use Windows Debugging Tool

The https://msdn.microsoft.com/library/windows/hardware/ff551063%20(v=vs.85).aspx
tools used by Microsoft software developers to analyze and resolve errors that result in memory dumps. Use the
tool to determine the cause of the error. Follow general steps for downloading, setting up, and using the
Windows 10 debugging tool. A similar process is used for Windows 7 or Windows 8.
NOTE: The following screen shots provide only an example of the tool. Specifics shown are not representative
of all applications of the debugging tool. This is a Microsoft tool supported by Microsoft.
90 Chapter 7 Troubleshooting guide
Use safe mode when removing or disabling components. Safe mode loads only the minimum
F8 at the menu that displays the operating system choices. At the resulting Windows
is one of the primary