Heat Sink - HP Z VR Backpack G1 Maintenance And Service Manual

Heat sink

Description
Heat sink
Follow these steps to remove the heat sink:
1. Shut down the computer. If you are unsure whether the computer is off or in hibernation, turn the
computer on, then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the top cover (see
5. Remove the fans (see
6. Remove the antenna (see
7. Remove the battery (see
8. Remove the SSD (see
9. Loosen eight captive retaining screws according to the numbered order stamped on the heat sink (1).
10. Lift and remove the heat sink (2).
Reverse this procedure to install the heat sink.
NOTE: When installing the heat sink, be sure to examine the areas where the components and the heat sink
come into contact to make sure the areas are properly covered by the thermal pads and paste.
Top Cover on page 14).
Fans on page 16).
Antennas on page 18).
Battery on page 19).
Solid state drive on page
Spare part number
L05348-001
20).
Component replacement procedures 21