Appliance Description; Settings - AEG MTD 350 Operation And Installation Manual

Operation - for users and contractors
2.2 General safety instructions
DANGER Scalding
During operation, the tap can reach temperatures in
excess of 50 °C.
There is a risk of scalding at outlet temperatures in
excess of 43 °C.
WARNING Injury
!
The appliance may be used by children aged 3 and
up and persons with reduced physical, sensory or
mental capabilities or a lack of experience and know-
how, provided that they are supervised or they have
been instructed on how to use the appliance safely
and have understood the resulting risks. Children
must never play with the appliance. Children must
never clean the appliance or perform user mainte-
nance unless they are supervised.
DANGER Electrocution
Any damaged power cables must be replaced by a
qualified electrician. This prevents potential hazards
from arising.
Material losses
!
Protect the appliance and tap against frost.
Material losses
!
Only use the special aerator provided. Prevent scale
build-up at the tap outlets (see chapter "Cleaning,
care and maintenance").
26
2.3 Test symbols
See type plate on the appliance.

3. Appliance description

The hydraulically controlled small instantaneous water
heater heats the water directly at the draw-off point.
The heating system starts automatically when the tap is
opened. The short pipe runs ensure that energy and water
losses are minimall.
The DHW output depends on the cold water temperature,
the heating output and the flow rate.
The bare wire heating system is suitable for hard and soft
water areas. This heating system has a low susceptibility
to scale build-up. The heating system ensures quick and
efficient DHW provision at the hand washbasin.
Fitting the special aerator supplied provides an optimum
water jet.

4. Settings

The appliance heating system switches on automatically
as soon as you open the DHW valve at the tap or activate
the sensor of a sensor tap. The water is heated. The water
temperature can be adjusted at the tap:
For the start volume, see chapter "Specification / Data
table / On".
Increasing the temperature
» Reduce the flow rate at the tap.
Reducing the temperature
» Open the tap further or add more cold water.