Technical Specifications - Electrolux e:line EOEM61CS User Manual

38 technical specifications

electrolux e:line ovens
Technical specifications
error code
F01 or 01
F02 or 02
F04 or 04
F05 or 05
25
26
6
F08 or 08
F09 or 09
C1
C3
F03 or 03
F14 or 14
Test Mode
• Within 10 seconds of powering up simultaneously press the timer button and start/stop time '+' button, this will enter
'TEST MODE' for a maximum of 5 minutes.
Firstly displayed will be the software version and model No. Then using the function ' ^ ' and 'v' buttons scroll through
door lock test (Pyro only) individual element and light, cooking fan, cooling fan and temperature probe etc. functions.
description
Door lock sensor alarm
Door lock actuator alarm
Oven Probe (PT500) out of
range alarm
Oven Probe (PT500) too high
temperature alarm
Board Temperature Sensor
(NTC) too high temperature
alarm
Board Temperature Sensor
(NTC) out of range warning
Board Temperature Sensor
(NTC) out of range alarm
Communication alarm
Software compatibility code
alarm
Telescopic runners fitted
Door open
EEPROM check sum alarm
EEPROM compatibility code
alarm
comment
This relates to a door lock
failure which is only associated
with the Pyro product
This relates to the temperature
sensing probe which may be
out of tolerance, or have open/
short circuit connections
This relates to the temperature
of the powerboard and/or the
temperature-sensing element
(NTC) on the powerboard
This relates to an error in
communication between
the powerboard and the IOI
controller. This can occur if
the IOI controller is connected
while the powerboard is
energised
This relates to a mismatch
between powerboard firmware
version and the IOI controller
firmware version. Most likely
caused by an un-programmed
powerboard
Only applies to Pyro product
Only applies to Pyro product
Relates to the controller
Relates to the controller
fix
Check wiring/plugs or
replace door lock
Replace probe
Cooling fan not working
or replace powerboard
Reset power. (Minimum of
20 sec.) or check or replace
data cable
Replace Powerboard
Remove both side racks and
re-start pyro cycle
Close door and restart pyro
cycle
Replace Controller
Replace Controller