Extended Self-Test Including Gps-Test - JRC JCY-1950 Instruction Manual

5.4.2

EXTENDED SELF-TEST including GPS-test

1. Release front cover by removing the cotter pin.
2. Move switch to "TEST" position twice within 3 seconds and release back to "READY" position.
3. A short beep sounds, and the test starts. During the test, until the capsule acquires the GPS
position, a short beep sounds every three seconds.
4. It's possible to determine the test results by the number of beeps. If the GPS has been
acquired successfully, a beep sounds consecutively twice.
Number of beeps
2
5
10
5. The NORMAL SELF-TEST is performed after successful GPS-test and position transmitted on
406.037MHz. The GPS position may also be received on the EPIRB tester for verification.
Table 5-4 Error message by beep
None
Did not acquire the GPS position
Number of GPS-test exceeds limit (> 60)
Chapter 5 About Float-free Capsule
The cotter pin
Fault indication
99