Registering The Handset; Handset Layout - RCA 25413RE3 User Manual

Connections and Setup

Registering the Handset

NOTE: Handset must be registered to the base to be operational.
Once a handset is registered it can use the base phone's connection. A
cordless handset will not operate until it is registered to a base. During
the registration process, keep the handset near the base.
NOTE: At initial power up, display will show "PLEASE REGISTER". To
continue registration from this point, proceed to step #4.
1. On the handset, press the MENU button once, and then press the
button until REGISTRATION shows on the display.
2. Press the SELECT/SAVE button or the STORE button to select
Registration mode.
3. Press the
4. Press SELECT/SAVE to confirm. The display shows REGISTER....
5. On the base, press and hold the PAGE button for 3 seconds. If the
registration is successful, the handset will emit a long beep.
6. If the registration fails, FAIL! TRY AGAIN will show on the handset
display. Please repeat the above steps.

Handset Layout

Volume Up/Down
(buttons)
Ringer ON/OFF
(switch)
FORMAT/REDIAL
(button)
MENU (button)
DIR (button)
DELETE/CHANNEL
(button)
PRIVACY (button)
TRANSFER/INT
(button)
CONF (button)
8
or button on the handset to select YES.
Display
STORE (button)
LINE (button)
TALK (button)
CID (button)
SELECT/SAVE
(button)
HOLD (button)
FLASH/EXIT
(button)
charge cradle with
power supply
charge indicator