Handset Sound Signals; Troubleshooting Guide; Telephone Solutions - RCA 25413RE3 User Manual

Handset Sound Signals

Signal
A long warbling tone (with ringer on)
Three short beeps
Two short beeps (every 2 seconds)
One short beep (every 6 seconds)

Troubleshooting Guide

Telephone Solutions

No dial tone
• Check and repeat installation steps:
Ensure the base power cord is connected to a working outlet.
Ensure the telephone line cord is connected to the base and the
wall jack .
• Connect another phone to the same jack; if there is still no dial
tone, the problem might be your wiring or local service.
• The cordless handset may be out of range of the base. Move
closer to the base.
• Ensure the battery is properly charged (12 hours).
• Ensure the battery pack installed correctly.
• Did the handset beep when you pressed the TALK button? The
battery may need to be charged.
Dial tone is OK, but can't dial out
• Make sure the type of phone service you are subscribed to is
TONE. This handset is TONE only.
Handset does not ring
• Make sure the handset ringer switch is turned on.
• The cordless handset may be out of range. Move closer to the base.
• You may have too many extension phones on your line. Try
unplugging some phones.
• Check for dial tone. If no dial tone is heard, see No dial tone above.
You experience static, noise, or fading in and out
• Change channels.
• The cordless handset may be out of range of the base. Move
closer to the base.
• Make sure base is not plugged into an outlet with another
household appliance.
• Charge the battery.
Unit beeps
• Clean charging contacts on cordless handset and charge cradle
with a soft cloth, remove comma or an eraser.
• See solutions for "No dial tone" on previous page.
• Replace the battery.
Troubleshooting Tips
Signals an incoming call
Error tone
Page signal
Low battery warning
Meaning
21