Advertisement
2023 O2 VAM
Apply Loctite 243 on bolt threads. Thread the
bolt in but do not tighten, this will allow the
insert to align when installing the axle
Remove the thru-axle and remove the hub. Install
front wheel and tighten the thru axle (with the nylon
washer) to 12Nm.
Install a front hub in the dropout with the free hub on
non-drive side. This will allow better access for the
next step. Install the thru-axle with the nylon washer
and tighten to 12Nm
After ensuring the dropout insert is correctly
aligned, tighten the dropout bolt to 1 Nm.
Advertisement
