4
Parts Replacement and Cleaning Procedure > Motors > Removing the Tray Auxiliary Guide Motor (M6)
Removing the Rear Alignment Motor (M5)
1) Remove the upper
2) Remove the 2 screws and disconnect the connector, and then remove the belt from the pully
processing tray unit
to remove the rear alignment motor.
(rear).
(Refer to page 4-12)
Removing the Tray Auxiliary Guide Motor (M6)
1) Remove the lower
2) Remove the 2 screws, and then remove the tray auxiliary guide motor.
processing tray unit.
(Refer to page 4-15)
4
Parts Replacement and Cleaning Procedure > Motors > Removing the Tray Auxiliary Guide Motor (M6)
x2
x1
x2
F-4-40
F-4-39
4-19
4-19