4
Parts Replacement and Cleaning Procedure > Main Units > Removing the Upper Processing Tray Unit (Front / Rear)
Removing the Upper Processing Tray Unit (Front / Rear)
1) Remove the front and rear covers.
5) Remove the 2 screws and disconnect the connector, and then release the harness from the harness
(Refer to page 4-7)
2) Remove the upper feed guide unit.
(Refer to page 4-8)
3) Remove the upper cover.
(Refer to page 4-9)
4) Remove the grate-shaped guide.
(Refer to page 4-10)
6) Remove the 2 E-rings and gear and bushing, and then remove the paddle unit.
4
Parts Replacement and Cleaning Procedure > Main Units > Removing the Upper Processing Tray Unit (Front / Rear)
guide to remove the paddle motor unit.
x2
x1
x1
F-4-23
F-4-22
4-12
4-12