Alignment / Shifting Operation - Canon Staple Finisher-R1 Service Manual

2
Technology > Processing Tray Unit > Alignment / Shifting Operation
The tray auxiliary guide slide-out amount varies depending on the operation mode and paper
length as follows:
Operation Mode Paper Length
Non-Sort / Sort 150 mm or more to less than
217 mm
217 mm or more to less than
300 mm
300 mm or more
Staple 150 mm or more to less than
217 mm
217 mm or more
2 Technology > Processing Tray Unit > Alignment / Shifting Operation
Amount of Slide Out
55 mm
55 + ("Paper Length" - 216) mm
120 mm
50 mm
55 + ("Paper Length" - 216) mm
T-2-4

Alignment / Shifting Operation

The paper stacked on the processing tray is aligned in the width direction by the front and
rear alignment plates. Then, the paper is shifted to the position where it is delivered to the
stack tray.
The front alignment plate is driven by the front alignment motor (M4) and the rear alignment
plate is driven by the rear alignment motor (M5). The home positions of the front and rear
alignment plates are detected by the front alignment plate HP sensor (S4) and rear alignment
plate HP sensor (S5).
Front Alignment Plate
Front Alignment Plate
HP Sensor (S4)
Front Alignment Motor (M4)
Rear Alignment Motor (M5)
2-10
Rear Alignment Plate
Rear Alignment Plate
HP Sensor (S5)
F-2-15
2-10