Table of Contents
Advertisement
ASSEMBLY
Make Assembly Easier
Everything in this manual is designed to ensure
that the weight bench can be assembled suc-
cessfully by almost anyone. Most people find
that if they set aside plenty of time, assembly
goes smoothly.
Before beginning assembly, carefully read the
following information and instructions:
• Assembly requires two persons.
• Make sure that there is enough clearance to walk
around the weight bench as you assemble it.
• For help identifying small parts, use the PART
IDENTIFICATION CHART on pages 5.
• As you assemble the weight bench, make sure all
parts are oriented as shown in the drawings.
1.
Before beginning assembly, make sure
that you have read and understand the
information in the box above.
Attach the Rear Stabilizer (2) to the Frame (1)
with four M10 x 20mm Screws (12) and four
M10 Washers (24).
2. Attach the Front Stabilizer (3) to the Frame (1)
with four M10 x 20mm Screws (12) and four
M10 Washers (24).
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
• Assembly requires the following tools:
the included hex key(s)
two adjustable wrenches
one rubber mallet
one Phillips screwdriver
Assembly may be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
1
1
24
12
2
1
24
3
24
12
6
2
24
12
12
Advertisement
Table of Contents
