Flavel Quasar NRDC MN2 Series Installation, Maintenance & User Instructions page 61

Table of Contents

Advertisement

Due to our policy of continual improvement and development the exact
accuracy of illustrations and descriptions contained in this book cannot be
guaranteed.
TROUBLE SHOOTING ADVICE FOR REMOTE CONTROL & ELECTRONIC
FIRE CONTROL MODELS PRIOR TO REQUESTING A SERVICE CALL
Please locate the Indicator light on the control valve behind the ashpan cover (see figure
4 on page 53), if it shows any of the following flashing sequences then the problem
requires the batteries in the control valve and / or handset changing, be advised that
service calls as a result of batteries requiring being changed in the product or
handset are chargeable.
a)
If the red indicator light flashes ONCE every ten seconds the batteries in the
control valve require changing, see section 5.7
If the red indicator light flashes TWICE every ten seconds the batteries in the
b)
handset require changing, see section 5.7
If the red indicator light flashes THREE times every ten seconds the batteries in
c)
the control valve and the handset require changing, see section 5.7
If these red indicator light flashes are ignored then eventually this will show as a flash
every second and your fire will cease to operate until the batteries are changed.
If a permanent red indicator light is shown after attempting to ignite the fire this signifies
no spark or no gas at the pilot and therefore a service call will be required to diagnose
the fault.
PLEASE ENSURE THIS ADVICE IS FOLLOWED TO AVOID BEING CHARGED FOR A
SERVICE CALL AS A RESULT OF BATTERIES REQUIRING TO BE CHANGED.
Telephone - General Enquiries :
Telephone - Service :
Part No. B-1001763
Issue 2
BFM Europe Ltd.
Trentham Lakes
Stoke-on-Trent
Staffordshire
ST4 4TJ
www.bfm-europe.com
(01782) 339000
(01782) 339008

Advertisement

Table of Contents
loading

This manual is also suitable for:

Quasar nrdc sn2 seriesQuasar nrdc rn3 series

Table of Contents