Interfaces
The below figures show the component side of the NVIDIA ConnectX-6 Dx adapter card. Each
numbered interface referenced in the figure is described in the following table with a link to
detailed information.
The ConnectX-6 Dx adapter card includes special circuits to protect from ESD shocks to the
card/server when plugging copper cables.
The below figures are for illustration purposes only and might not reflect the current
revision of the adapter card.
NVIDIA ConenctX-6 Dx for OCP 3.0 Adapter Card Interfaces - Component Side
Call
out
1
ConnectX-6 Dx IC
2
PCI Express
Interface
3
Ethernet
Networking
Interface
4
Networking Ports
LEDs Interface
FRU EEPROM
SMBus Interface
Voltage Regulators
CPLD Interface
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Item
NVIDIA ConnectX-6 Dx IC on the board.
PCIe Gen 3.0/4.0 through an x16 edge connector.
Ethernet traffic is transmitted through the adapter's SFP28/SFP56/QSFP56
connectors. The networking connectors allow for the use of modules, optical and
passive cable interconnect solutions.
There are two I/O LEDs, LED0 and LED1, per port to indicate speed and link
status.
FRU EEPROM capacity 4Kb
Allows BMC connectivity using MCTP over SMBus or MCTP over PCIe protocols.
Voltage supply pins that feed onboard regulators.
Controls the networking port LEDs.
Description
15