Auxiliary Feature (2Nd Burner Feature); Eco Mode; Circulating Fan Operation - Maxitrol GV60 Installation And Operating Instructions Manual

OPERATING INSTRUCTIONS
SELECTED
AM
PM
ON
OFF
1 2
AM
PM
ON
OFF
1 2
NOTE: Either continue to PROGRAM 2 and set on and off times
or stop programming at this point, and PROGRAM 2 re-
mains deactivated.
NOTE: PROGRAM 1 and 2 use the same on (Thermostatic) and
off temperatures for
, ). Once a new on (Thermostatic) and / or off tempera-
ture has been set, that temperature becomes the new
default setting.
NOTE: If , or Daily Timer are programmed for PRO-
GRAM 1 and PROGRAM 2 on and off times, these be-
come the new default times. The batteries must be re-
moved to clear the PROGRAM 1 and PROGRAM 2 on
and off times and temperatures.
or Daily Timer ( , , , , , , ) selected
▪ Set on time and off time using same procedure as "
lected" (above).
▪ : Set on time and off time for both Saturday and Sunday.
▪ Daily Timer: Unique on and off times may be set for a single
day of the week, for multiple days of the week, or for every day
of the week.
▪ Wait to finish setting.
30/ 33
ON TIME SETTING (PROGRAM 1):
7. , , displayed,
shortly, and hour flashes.
8. To select hour press or
9. To confirm press button.
displayed, displayed shortly,
and minutes flash.
10. To select minutes press
ton.
11. To confirm press button.
OFF TIME SETTING (PROGRAM 1):
12. , , displayed,
shortly, and hour flashes.
13. To select hour, press
14. To confirm press button.
displayed, displayed short-
ly, and minutes flash.
15. To select minutes press
ton.
16. To confirm press button.
, and Daily Timer ( , , , , ,

AUXILIARY FEATURE (2ND BURNER FEATURE)

The latching solenoid valve will open automatically after ignition
is displayed or after switching the system off, so that the maximum flow of
gas is supplied to both burners assisting with the ignition pro-
button. cess. After pressing the AUX-Button the motor will turn 7 sec-
, , onds in the ON direction until the max. position is reached.
or but-
ON
OFF
1 2
is displayed
or button.
, ,
NOTE: The latching solenoid valve cannot operate manually. If
or but- the receiver battery runs down it will remain in the last
operating position.

ECO MODE

CIRCULATING FAN OPERATION

se-
NOTE: SETTING only. If the fan was not switched off after last
use, it starts automatically 4 minutes after ignition at max-
imum speed and goes to the last set level after 10 sec-
onds. The fan stops 10 minutes after the gas is OFF or
at pilot.
ON:
To switch a burner on, press the
AM
ton. displayed.
PM
OFF:
To switch the burner off, press the
button. disappears.
ON:
Press button to enter Eco Mode.
AM
displayed.
OFF:
Press button.
Circulating fan has 4 speed levels from
low (1 bar) to high (4 bars).
AM
SETTING:
1. Press button and hold until
flashes.
2. Press button to increase fan speed
and button to decrease fan speed.
3. To confirm setting either press
ton or wait (
OFF:
Press button until all 4 speed level
bars disappear.
FOR OEM USE ONLY
but-
disappears.
but-
displayed).