Maxitrol GV60 Installation And Operating Instructions Manual page 4

OPERATING INSTRUCTIONS
NOTICE
To connect myfire Wi-Fi Box to Wi-Fi Router (Home Network),
make sure:
▪ Home Network is available.
▪ Home Network name and password are correct.
▪ SSID of the Wi-Fi Router is not hidden.
▪ Home Network signal is in range.
▪ Wi-Fi Router supports User Datagram Protocol (UDP).
CONNECT SMART DEVICE TO WI-FI ROUTER
NOTE: After successful connection a pop-up will tell you to go to
your smart device Wi-Fi settings.
1. Touch "OK" button, if correct.
CONFIRM FIREPLACE SETTINGS
1. After confirming fireplace settings touch "Finish" button.
A LIST OF CONNECTED MYFIRE WI-FI BOXES IS DISPLAYED
1. Touch "Start App" button to finish installation and setup process.
The home screen is displayed and the myfire app is ready to go.
NOTICE
After setting up the myfire Wi-Fi Box and myfire App, the time
has to be synchronized in the settings of the myfire App.
NOTICE
The active device (Symax handset or smart device) is the one
last used. An exception is if the non-active devise is used to
change Light, Fan, or AUX. The non-active device will make the
changes, but the active device remains so if it is in Thermostatic,
Program, or Eco Mode. If a Profile includes a Thermostatic,
Program, or Eco setting it will also cause the active device to
remain active.
NOTICE
If Thermostatic, Program, or Eco Mode is activated using the
app, the corresponding icon and "
handset (see figure 25).
Figure 25: App connected (in Thermostatic Mode)
NOTICE
During motor movement no information between receiver and
transmitter is exchanged. The synchronization follows after
motor has stopped.
NOTICE
The room temperature data is transferred by the Handset during
synchronization.
16 / 33
" is displayed on the
FOR OEM USE ONLY