Table of Contents
Advertisement
b Remove the two screws located on the back of your RackStation. Then slide the top cover in the direction
indicated below and lift.
Important:
Removing the cover will expose sensitive internal components to possible harm. Please avoid touching
any other components when adding or removing memory.
4 To insert the new memory module, follow the steps below:
a Align the notch on the gold edge of the module with the notch in the memory slot.
b Use two fingers to apply firm, even pressure and push the memory module downward.
c When the memory is inserted correctly, the ejectors will snap into place.
5 Replace the top cover, slide it into place, and tighten the two screws on the back of your RackStation.
10 Chapter 2: Hardware Setup
Advertisement
Table of Contents
